 |
 |
|
|
|
| karyap |
 |
| quartz sand, cement, walocel mkx 70000 pp 01, elotex ap 200 |
 |
Cement based Adhesive using introduction:
? Kg adhesive should be added to on aprroximately 250 ?300 gr. water and it must be mixed preferably with a slow rotating mixer, until a homogenous mixture is obtained. After prepared mortar rested approximately 15 minutes. It must be mixed 1-2 minutes before application.
•Adhesive Is pressed on the surface with a trowel until thin layer Is obtained, then it is combed with a suitably serrated travel.
•Following the combing, tiles must be placed within 15 minutes. If this perios is exceeded mortar must be scraped off the surface.
•For a good adhering, air must be thrown out with the help of plastic hammer.
•Surfaces will be ready for the tile joint filler 24 hours after application (for vertical surfaces). It must be waited 48 ?72 hours for horizontal surfaces to apply tile joint filler.
Cement based tile joint filler using introduction:
?0 Kg. cement based tile joint filler should be added 7 lt. water and it must be mixed with slow rotating mixer, until a homogenous mixture is obtained. After prepared mortar rested approximately 15 minutes. It must be mixed 1-2 minutes before application.
•Mortar must be filled into groud cavities with hard rubber trowel. It must be applied first parallel and then diagonal for a good filling.
•The surface must be cleaned an hours later by cross movements without pressing with a hard and humid sponge.
•After 5 hours later the surface must be moisted with wet sponge.
|
 |
CEMENT BASED ADHES?E AND TILE JOINT FILLER APPLICATION FIELDS AND SPECIAL FEATURES
•All cement based, plaster, concrete, alum, and cement based surfaces.
•Very good adhesive in wet and dry environments. (Kitchen, bathrooms, toilet, terrace etc.) And if prepared and applied according to instructions, it’s higly water, heat and frost resistant.
•Suitable for indoor & outdoor and vertical & horizontal applications (vertical applications its possible for light items, like faince and ceramics)
•Resistant to water and frost.
•Easy to apply, and high stability
|
| Industrial field |
adhesive & sealant |
|
|
 |
|
|
|
|
|
 |
| There are no existing companies to distribute selected chemical product |
|
 |
|
|
|
